There are several methods to choose from when it comes to HVAC fabrication. Using a brake press is the easiest and most cost effective method. A brake press bends metal to any specification you can imagine. It is perfect for bending metal for air ducts that need to be very precise dimensions.
A brake press can also be used to form retrofits for old air conditioners and furnaces that need to be updated for one reason or another. A brake press in Phoenix, AZ can also bend metal to customize roof flashings for your home or commercial building.
Duct fabrication
The air duct systems throughout our homes and commercial buildings are incredibly complex. They twist and turn throughout the structure to ensure proper air flow from the HVAC system to rooms in the building. With so many necessary twists and curves throughout the building, manufacturers need an effective way to bend the metal needed for ducts. Manufacturers also want to keep costs as low as possible. Enter the brake press system.
Brake press can quickly and efficiently fold metal into any shape. Modern brake press systems are able to load a program to make any shape in under 15 seconds, and have a complete product in about five minutes depending on the size of the project!
Our system is capable of handling 12 foot sheets of metal that are up to 3/8 of an inch thick. That’s plenty of power to create your next air duct system.
Recover old ACs and furnaces
Older ACs and furnaces might work just fine, but after a while they may need to be retrofitted with a new housing. Over time rust might build up on the outside of the system or the casing may have dents or other signs of wear and tear.
If the system is still running fine and only looks bad from the outside, there’s no reason to replace the whole unit. That’s a huge waste of money! Instead, contact us and we can use our brake press in Phoenix, AZ to quickly create new housing for your system. We can accommodate any size and dimensions you need.
Another reason to hire us to create new casing for your AC or furnace is if you’ve had to replace parts of the system and the old casing no longer fits properly. You can’t very well have new parts of your AC or furnace uncovered and hanging out of the original housing.
Fabricate roof flashings
A proper HVAC system isn’t complete without roof flashings. The thin metal pieces around HVAC vents on your roof work to prevent weather damage to your system. A brake press in Phoenix, AZ is the easiest, quickest, and cheapest way to fabricate these essential pieces.
Not that long ago it would’ve taken several pieces of metal and a few hours to fabricate these kinds of parts for your HVAC system. Today, it takes just one piece of metal and mere minutes to accomplish the same task. Contact us at 602-224-2262 to find out how we can put our brake press to work for you!